UPM-2 UltraSeries Reinforcement Loudspeaker

UPM-2 UltraSeries Reinforcement Loudspeaker

Specifications

Acoustical

Frequency Response(1)	...
Half Space	...	+4 dB 60 Hz - 20 kHz
Free Air	...	+4 dB 70 Hz - 20 kHz
Maximum SPL (2)	...
Continuous	...	108 dB
Peak	...	118 dB

Coverage

Horizontal	...	45°
Vertical	...	45°

Transducers

Low Frequency	...	Two 5-inch cone drivers, 8 ohms per driver
High Frequency	...	1" Titanium dome horn driver, 8 ohms

Passive Network

Function	...	3-way crossover and HF driver protection
Capacitor Type	...	Polypropylene
Inductor Type	...	Ferrite core

Nominal Impedence

...

16 ohms

P-2 Control Electronics Unit

Specifications

Input Type	...	Balanced (active), 47k ohms
Output Type	...	Push-pull (active), 200 ohms source impedance
Max. Input/Output Level (3)	...	Balanced: >+26 dBu / Unbalanced: >+20 dBu
Hum and Noise (4)	...	<-90 dBV
Dynamic Range (5)	...	>105 dB
Sense Input	...	10K ohms true differential
Driver Protection Circuitry	...
Low Frequency	...	RMS limiter
High Frequency	...	RMS and Peak Limiter

Indicators

Sense	...	Green LED
Limit		Red LED
Power	...	Green LED

Controls

...

Level Control, AC on/off switch, Lo Cut Switch

Connectors

Balanced Inputs/Output	...	3-pin XLR (A-3)
Sense Inputs	...	Banana jacks

Notes

1. Measured 1 meter on axis, pink noise input, in thirdoctave ISO bands.

2. “A”-weighted noise input, loudspeaker driven by 125 watt (16 ohm rating) mono amplifier.

3. 1 kHz, 10k W load, < 0.1% THD.

4. “A” weighted.

5. Noise floor to maximum output.

Architect
Specifications

Datasheet (PDF)

Operating Instructions (PDF)

P-2 Operating Instructions (PDF)

Contact Us | Terms of Use | Trademarks
Copyright © 2008 Meyer Sound Laboratories Inc.