MILO

MILO SPECIFICATIONS AND DIMENSIONS

Operating Frequency Range(1)

60 Hz - 18 kHz

Frequency Response(2)

65 Hz - 17.5 kHz ±4 dB

Maximum Peak SPL(3)

140 dB @ 1 m

Coverage

90° Horiz. (vertical varies with array length and configuration)

Transducers: Low/Low-Mid Frequency(4)

Two 12" cone drivers with neodymium magnets
Nominal impedance: 4 Ω
Voice coil size: 4"
Power-handling capability: 1200 W (AES)(5)

Transducers: Mid-High Frequency

One 4" compression driver
Nominal impedance: 8 Ω
Voice coil size: 4"
Diaphragm size: 4"
Exit size: 1.5"
Power handling capability: 250 W (AES)(5) on REM

Transducers: Very-High Frequency(6)

Three 2" compression drivers
Nominal impedance: 12 Ω
Voice coil size: 2"
Diaphragm size: 2"
Exit size: 0.75"
Power handling capability: 100 W (AES)(5) on REM

Amplifier Power

3935 W (Four channels: three x 1125 W, one x 560 W)(7)

Automatic Voltage Selection

Automatic, two ranges, each with high-low voltage tap

Safety Agency Rated Operating Range

95 V AC – 125 V AC, 208 V AC - 235 V AC; 50/60 Hz

Turn-on and Turn-off Points

85 V AC – 134 V AC; 165 V AC - 264 V AC

Audio Connector

Female XLR input and male XLR loop output or VEAM connector (integrates AC, audio and network)

AC Connector

250 V AC NEMA L6-20 (twist lock) inlet, IEC 309 male inlet or VEAM connector

Max. Long-term Cont. Current Draw (>10 sec)

11.2 A RMS (115 V AC); 5.6 A RMS (230 V AC); 12.9 A RMS (100 V AC)

Notes

1. Recommended maximum operating frequency range. Response depends upon loading conditions and room acoustics.
2. Measured with 1/3 octave frequency resolution at 4 meters.
3. Measured with music at 1 meter.
4. To eliminate interference at short wavelengths, the two 12-inch cone drivers work in combination at low frequencies (60 Hz – 300 Hz). At mid frequencies (300 Hz – 560 Hz) only one cone driver is fed from the crossover to maintain optimal polar and frequency response characteristics. Attenuation on the other driver: -6dB at 300Hz, -12dB at 400Hz, -18db at 500Hz.
5. Power handling is measured under AES standard conditions: transducer driven continuously for two hours with band limited noise signal having a 6 dB peak-average ratio.
6. The three drivers are coupled to a constant-directivity horn through a proprietary acoustical combining manifold (REM).
7. Amplifier wattage rating is based on the maximum unclipped burst sine-wave rms voltage the amplifier will produce in to the nominal load impedence. Low, low-mid and very-high frequency channels 67 V rms (95 V pk) into 4 ohms; mid-high frequency channel 67 V rms (95 V pk) into 8 ohms.