Meyer Sound
Meyer Sound Logo
SIM® System II Logo

SIM-2201 Sound Analyzer Specifications

Frequency Range 8 Hz to 22 kHz
Screen Update Rate <0.7 sec (Frequency Response or Spectrum Mode)
0.2 sec to 1.3 sec (Delay Finder Mode) 1
Frequency Resolution
Frequency Response Mode (Transfer Function) 1/3, 1/6, 1/24 octave (selectable)
Spectrum Mode (Single Channel) 1/6 octave (fixed)
Averaging of Data
Frequency Response Mode 2 to 16 Vector or RMS, sliding, performed on a per-frequency-bin basis
Delay Finder Mode 1 to 999 Vector, linear accumulator
Delay Finder Accuracy ±10 µsec time, ±0.5 dB amplitude (lower trace)
Amplitude Accuracy (Frequency Response and Spectrum Modes)
Absolute ±0.1 dB 20 Hz to 20 kHz, Input (A) and Output (B); ±0.15 dB 20 Hz to 20 kHz, Mic (C)
-1 dB Points 8 Hz and 22.5 kHz
Channel Matching 0.1 dB Input (A) to Output (B), 10 Hz to 20 kHz, ±1 degree phase matching
0.4 dB Input (A) or Output (B) to Mic (C), 20 Hz to 20 kHz
Signal Analysis Linearity THD <0.025% with full scale signal
Minimum Resolvable Signal
Input (A), Output (B) < -90 dBV Spectrum Mode (<-105 dBV midband), <-70 dBV Frequency Response Mode
Mic (C) <-115 dBV Spectrum Mode, <-75 dBV Frequency Response Mode
Maximum Measurement Signal Range <1 µVrms (Mic channel) to >28Vpk (A or B Input)
Gain Range -20 to +50 dB relative gain, switched in eight 10 dB steps
Measurement Inputs
Impedance 10k ohms (A or B) balanced ISO™ Input, 5k ohms unbalanced; 8k ohms (mic), balanced
Phantom Power (Mic only) 48 VDC ±2 V, switchable on/off
Maximum Input Signal 26.0 dBV Input (A), Output (B), -4.0 dBV Mic (C)
A/D Converters (3 simultaneous channels)
Type 16 bit Sigma Delta, 64 times oversampling, 3rd order noise shaping for 94 dB dynamic range
Anti-aliasing filters 30-pole FIR digital and 5th order linear phase analog
Signal Generator
Output 300 ohms balanced, 24 Vpk maximum output level
Sine Wave 16 Hz to 22 kHz tunable in two ranges, <0.01% THD 100 Hz to 22 kHz, <0.1% THD at 16 Hz
Noise Pink spectrum ±1.5 dB, 20 Hz to 20 kHz
Pulse (Frequency Weighted) Average repetition rate 1.25 sec, time modulated
Physical
Storage 1.44 Mbyte floppy disk drive, 120 Mbyte removable hard drive, 16 Mbyte internal RAM
Front Panel
Controls

Source Level control, Sine Frequency, Phantom Power switch, Phones Level control, Phones source select switches (3), System Reset switch
Indicators


Power, Disk, Generator source waveforms on/off, Phantom power on/off, Measurement inputs on/off, Phones sources on/off, Measurement input levels (20 segment LED bar displays), Input Overload
Connectors

Input (A), Output (B) and Mic (C), 3-pin XLR female; Source, 3-pin XLR male; Phones, 3 circuit monophonic 1/4-inch phone jack, 32 ohms minimum impedance; Keyboard, 5-pin DIN
Rear Panel Connectors


Audio Interface, 39-pin Whirlwind W-1 female; Control Bus, D-25 female; Video Output, D-15 high density male; Serial Interface, D-9 male; RS-232 Serial Interface, D-25 male; Parallel Interface, D-25 female; Power, IEC receptacle
Power 90-250 VAC switchable in two ranges, 50/60 Hz, 300 watts
Dimensions 19" W x 7" H x 24" D
Shipping Weight 60 lbs (27 kg) including keyboard, cables, software and manual, without video monitor

Footnotes:

  1. Screen update rate in Delay Find Mode is dependent on record length.

 

Contact Us | Terms of Use | Trademarks
Copyright © 2008 Meyer Sound Laboratories Inc.